Well it was fun while building it, now it just sits in corner and working, just like that :yawn: I don't know how much it weights, but only i...
THX ALL ! You've been a great audience :D :rock:
But here is some pictures at dark. that scanner neon light is not that strong afterall but I'll leave it inside anyway ;) [IMG] and here is...
Here is finally finished ! Took some pictures of parts that will hardly be seen throught that greenish reservoir ;) Got case outside, cause...
firstly 2 Claas M : I've tryed all positions in hope that pump will get water and start pumping it around but it was quite impossible, that's why...
Ok, reservoir doesn't leak so I've connect remaining tubes ... [IMG] Sweet look through window ;) [IMG] I've fill system with water...
Offcourse there is splitter for blocks and after blocks all water "connects" in reservoir ... you could clicks few earlier updates and you would...
2 Mankz_91: it wasn't that much expensicve, much more cost me those brass connectors ... While waiting for friend to bring me relay for pump,...
Reservoir is reasembled and sealed so it's time to put some water to see will it hold it inside ... [IMG] ... and yes, it holds ;) one...
I was thinking about that, but don't know what liquid to use, and where to get it localy ... I'll do some research and see if I can get it ... and...
After motherboard is all assembled, next is graphic card. You've already seen it but it's nice ... and still damn heavy ;) [IMG] ... but...
thx guys for support ! I'we been on trip (not drugs :D) for some time and wasn't able to make update. But here is little one :) ... pump can't...
Yes, every single block is pretty heavy, and motherboard itself has a "few", but it doesn't seem like a problem as motherboard is attached with 6...
this rad could probably work without fans ... but when i finally run it, then i'll know for sure ...
Power suppy is assembled ... [IMG] [IMG] [IMG] [IMG] I didn't make a block for southbrigde, but as it can get pretty warm and I...
Short update ... Done a volt mod, actually my friend Vlado aka Franky ;) did it, and he did almost impossible - solder a resistor on super tiny...
After some time running the pump it's pretty quiet, actually you can't here it unles you put your ear on it ;) But it slightly vibrate, not much...
Same thing is what I've done on my PSU, make blocks the same size as original aluminum ones, and leave enough place for original fan so there will...
thx all still have some issues with some scanner light electronics and how to make it work ... but anyway when is all done, i'll take some...
Finally update ! ... i get the pump ! ... and here it is, in all it's glory ;) [IMG] it's pretty big, little bigger than i expected but i...
Separate names with a comma.