you can get el-cheapo mini-hubs for us$7-10... not thaat expensive :P
are you planning on cutting out the sockets or just removing the bulbs? You could try paint or tape to obscure the light, though it would have a...
I've got daisy chained hubs that work just fine, its alot more expensive than just the cable but should do the job :/
Mine heats up a bit. I left the backlight on full 5v for an hour or so once without knowing it and the screen was totally washed out an the thing...
the sunlight will give you just as much IR trouble as Red... We were doing an IR following robot that would get screwed up if the sun was shining...
NiMH batteries are charged differently than NiCd, It'sbest to get a charger made for NiMH or one that can switch between the two. You said you...
ya... so you just want a continuous stream of all the cd text information? Scrolling all in a line or scrolling a track to a line??? I find it...
be careful as current adds in parallel, so you're looking at about 46ma that way...
can you reheat it with your iron then wipe it away?
Unless it's so late that I'm losing it, I don't know how you look at it like that. The diagram and the explanation both say that the energized/NO...
thats the easiest way, keep it flipped for as long as you'd push your power button in to start it up...
I don't know what software meblin is including/recommending, but getting (win)lirc and whatever controller you use is a little more setup than...
http://catalogs.google.com/catalog_list that doesn't have em all, but it has alot, i dont know about other uk stores but it doesn't have...
If you're near dayton, mendelsons has some on the electronics floor that can be modded... They're short and the ends are a bit bulky, but they...
I don't exactly know what you mean, they have 6-8 kinds in use all over our campus, here's some retail possibilities depending on what you want......
power them with your power supply, then plug the rca/phono jack into the tv-out on your video card.
look at page 3, not much info but it should be possible
you've gotta factor in solder, and you save time and space too...
<snip> he fixed it
use the rheo temporarily, figure out a good setting, then measure the resistance and copy with a fixed resistor
Separate names with a comma.