I shall name it Squishy, and it shall be my squishy! Run caps and R507 decided to show up (that cylinder took 3 weeks to get here from Hawaii,...
She's all plumbed on up! [IMG]
Hey a little update; she's all brazed up except the flex and evaporator (still need to decide who's Evap is going on this!). So I began to...
For anyone watching the time; planning out something like this can be complex. Or it can be drawn on a napkin. And then immediately done. For...
Well; who likes water chillers? :eek: So I was sitting in the workshop, I'm cranking out on ECI 33+ the big 3 stager and decided I might as well...
[IMG] Everything but the connections to the box are done; box is now being slightly remade to have a bit more support and insulation for the...
[IMG] About time! Okay so this had a 1/3hp 230vac motor on here. Sadly this meant that, to get a 110vac motor and keep the same fan grill and fan...
Holy flying pink nimbus cloud of heat exchanger goodness! Points to anyone who can say that five times fast. So, my welding has been getting...
She's almost totally piped up. Just waiting on the condenser fan. Big 1/3hp 3 speed that will probably get turned way the hell down but was the...
Obviously I haven't touched this in a while. Had shoulder surgery and medical school keeps you low on time. So back to work on it. Today I...
It's a 1/5hp little unit, r404a compressor, copeland. Chilly1 blue with 100cfm 110vac fan. 20" Flex line, Chilly1 evaporator, unmodified. 250W @...
The base is 38" x 19". I expect it to be 24" tall.
1" steel square beam (2.54cm square). Not sure if it's going to get any paint actually. But here is the base finished. 1.25 inch squares were cut...
Started on the steel frame. Simple spot welds, then a nice line on the insides. Have to get a piece of MDF tomorrow, slot the corners, weld up the...
Obviously its been sitting. I'll be back to get her good and ready to ship out. Few nice little items that she's going to get. Updates in a little...
Obviously it's been a while. Fall semester has been going pretty well, but I will be back on this. Especially since I finally found the dream...
Haha rebuilding my load tester today.
Due to the low restriction in that style of block on the GPU's, you should consider running them in parallel. Switching the bottom connection on...
The ice gods visited... [IMG]
And she's holding just fine, guess I've still got it ;) Onto vacuuming. Ice tomorrow most likely or a bit later tonight! Time to wire.
Separate names with a comma.