You say "Our electronics dept. only has 7-segment displays that deal with binary". Do you mean that each of the seven segments has its own pin?...
Sorry richard-wong, I didn’t mean to insult. :blush: I know I get flustered when every thing breaks at once.
4028 is a 1 of 10 decoder. The 4511 is for common cathode and the 4543 can be used for either common anode or common cathode 7 segments. Also...
I know it’s obvious, but did you try to replace the battery in the DMM? Only thing I can think of for the soldering iron is to test the outlet...
Great idea! :idea: It fulfils the original requirement "i'd like to display this number in decimal on two seven segment displays." and is more...
Sorry, was not suggesting to download build17, just that it started Itune support at 17. As I can tell Henri is always making LCDinfo better so...
That PPROM (read article) is worse than his present solution. Another solution is to use a 8bit wide programmable memory. The smallest I could...
Thanks for the info coorz. Poked around at LCDinfo (Link in sig above) and version 0.6 build 17 supports iTunes. zer0_c00l started the thread...
A quick scan thru my chip books found TTL 7447 but the A-F characters are weird and the CMOS 4511 only decodes 0-9. There are hex displays...
I buy mine from Chi Wing thru E-Bay in large lots. The only drawback I have found is the optics (clear housing) is not as high of quality as the...
If it is a tachometer output the signal is an open collector at two pulses per revolution.
The hardware should not be a problem as there are many examples and guides. The software may be difficult as I have not heard of an interface with...
Should work. Make sure you get the wires in the correct positions on the connector. Ground-Power-PulseOut
Transfer? You can transfer classic WUs to BOINC? If I can transfer WUs I might just convert before they make me. So, can they be transferred?
1000WU (Classic) Just passed the 1000WU mark in classic SETI. I do not think I will change over until I have to. :clap:
-5 Vdc I am looking at the ATX link above and the PSU guide at formfactors.org and notice that the -5Vdc line on the 20pin ATX connector shows as...
Every thing is water cooled? Are you including the CPU power FETS, Southbridge, and ICH. Their are a lot of little parts on the MB that get hot...
Yes a SPDT switch on the positive side (Red wire) of the fan will switch between +12 and +5 if the other side of the fan is connected to ground...
This gives me the idea for a new mod style. the “OOPs” mod. Lots of cracked plexi, miss drilled holes, over cuts and the like. Place plexi over...
I have bought several items from the seller and he is a good source. As for the display itself you would have to compare it in price to other...
Separate names with a comma.