Alright its been awhile, but I'm in the middle of planning my wedding and coordinating family travel. I attempted the silicone method Cheapskate...
Do you let the silicone fully cure? I tried teflon tape, and also pipe thread sealant which usually holds. Either way I'm shipping in some new...
So I spent about half the weekend fiddling with it, and realized I bored one of the pump mounts into one of the water channels. I tried everything...
I thought of that too, all my main chassis pieces are index-able for my cnc so I could always put mounting feet into the back IO plate if I have...
Yes it is. I can't believe I missed that, especially since I fix boilers and pumps for a living. I guess overconfidence is the worst form of...
Finally got around to the top of the plate, I got so excited I pulled it off the machine before finishing the ports for the g1/4 [IMG] I put it...
Just a quick update, got the bottom part of the distro plate cut, will be moving on the second part next week. First time every trying one, hope...
Apologies for my delay, I was out of town. Thank you for the welcome! I did not even think of going with a wood insert, I'll have to toss that...
Hi guys I had no intention of keeping a build log, but here it is. This build started because my 11,000 sq. ft. office flooded (I would blame the...
Separate names with a comma.