a latching relay would do the task I need it to do, but there's one problem! It's too sensitive to shock and vibration. To give you an idea of...
yes, a relay is mechanical, but the problem is that it's momentary. Even if it wasn't momentary, it's too subseptable to shock and vibration for...
I think I might be able to use an actuator. The problem I have with the solonoid is it's momentary just like the relay. As soon as the voltage...
basically I need a device that operates an on/off switch. Let me explain it more in detail: The device will control the flow of voltage like an...
I looked and didn't see anything. You're refering to Liniar's IC workshop right? I really don't see anything there about a DIY voltmeter
I can't use a pre-made one because I'm mounting it in my car. It's only purpose will be to read the knock sensor on my engine. So basically can...
way to bring this thread back from the dead! it's a year old :hehe:
whatis th exact name of that relay and what's the definition of a latch?
not to worry, I'm not worried about the engine cranking without any fuel. It's running the engine lean that can be dangerous (that's when the...
Is important that the fuel pump be ON while the alarm is armed. Let me put it this way, the fuel pump should ALWAYS be on, I need it for my...
my alarm is an aftermarket one and I know where all the wires are so it's not a problem. When the alarm is set of, 12V is sent to the siren. A...
Great idea! All I need now is for someone who know about circuits to help me out (cause I sure as hell ain't going to be able to figure it out!)
that'd be too much of a hassle to carry something like that with me. I know this car be done just the way I described it, I just need to find...
It's an 1999 Acura Integra GSR. I like the fuel pump idea better because the car will run for a couple seconds and shut off. That way the thief...
^ that's correct, but it's even worse for my car's engine to be stolen:rolleyes:
If it trips while moving, the car stalls. However, that's a chance I'm willing to take. Does anybody know how to do this with electronics?
I need a fuse that can be reset like a house fuse. My idea is to implement this into a car's security system. Here's the idea: The fuse control...
well I don't have a lot of money to spend and I'm upgrading from a TNT2 so I can live with a GeForce3 TI200 or GeForce4 MX440. I don't play a lot...
Which do you think is better for roughly the same price, a GeForce3 TI200, or a GeForce4 MX440?
Great! just what I was looking for, thanks
Separate names with a comma.