I wouldn't say he "lent" it to her, Linear. I doubt he wants it back. :rolleyes:
...after you clear coat them, of course. ;)
You may try sanding down the edges of the drive's face plate. I'm assuming you're doing the "press the corner of the drive bay cover and out pops...
Try this place.
I know we had a hell of a time tracking MIC502s down over on the [H]ardForums, but then a guy named choatie88 found a supplier and we did a mass...
Why the h3ll was this post moved into the Electronics forum?
Their site seems hard to get to because the URL is wrong. Put a '-' between 'virtual' and 'hideout' and it should work just fine. Like this. Enjoy.
Check out Cliff's FanBus -- specifically, The Lab.
Why? My room has windows and I don't know anyone who works at a plastic company. :D
Have you tried flipping the LEDs around? You may have wired them backwards by mistake.
I think Cold Dog was the man behind this mod. You might try PMing him over on the [H]ardForums. I'm not sure if he frequents these forums or not.
Hah! Spoken like a true modder...who cares if it works, as long as it looks cool! :D Outstanding job. Looks beautiful, bro.
Ideal fan setup is to intake cool air low and exhaust hot air high. Blowholes, then, work on the "exhaust hot air high" side of the house,...
Try this. It's from the Cliff's FanBus website.
FYI: If you decide to buy them, you're looking for Dremel part number 426. The mandrel, which is required, is Dremel part number 402.
Slow does not necessarily equal bad. Patience is the key to professional looking mods. Again, good luck. :)
And here's my two cents... 1. Some specifics on the Dremel side of the house (should you choose that route -- and I highly recommend that you...
Huh?
Dremel. Period. The RotoZip, in my opinion, is small on features and big on size. The Dremel, with its wide array of bits and compact size,...
Alas, I must add one more OT post to the foray... Alaric: I was in no way flaming you, friend. In retrospect, it may look as though I singled...
Separate names with a comma.