Hi, just wondering does anyone have an accurate 120mm fan done in autocad that i could have / use? Thanks N4N01D
I use to have one m8, but I formated to create RAID 0 on my pc. Its easy to make one. Here are the step. For 3D it will be a little harder, but this guid should help. Make a box 120mm X 120mm the create and a line fron corner to corner. Were they meat create a cicrle with R 6. BTW make sure you are in mm and 1:1 box and snap. the measure the hole in the fan fro the screw with a drill bit. One by one till the one drill bit fits nicely. Then measure the wall were the screw it and create a line the is the length of the wall of the fan and half the length of the screw. I like the KIS method so you can only make 1/4 of the fan and mirror the rest. Good luck m8, this shouldn't take more then 3min to create.
aye, but i need very detailed measurements, eg mouting hole dia, the radius on corners etc, i would do it but i dont have a free 120mm fan atm and iirc the fans arent exactly 120mm spot on
