Electronics BackLit LCD's

Discussion in 'Modding' started by HowY, 19 Dec 2008.

  1. HowY

    HowY What's a Dremel?

    Joined:
    14 Feb 2005
    Posts:
    112
    Likes Received:
    0
    Hey

    I've a question about backlit LCD'd (2x16)

    Looking at an additional two pins...
    +5v and Gnd for powering the backlight.

    Can I just tap the LCD's power pin or
    is an additional resistor needed for the
    backlight led....?

    Or simply, is a resistor needed for the
    backlight wiring of this type of LCD?

    As always my best
    :dremel:
    HowY
     
  2. thehippoz

    thehippoz What's a Dremel?

    Joined:
    19 Dec 2008
    Posts:
    5,780
    Likes Received:
    174
    use a multimeter =] those led's are typically +5VDC power
     
  3. Skylined

    Skylined Minimodder

    Joined:
    3 May 2003
    Posts:
    1,146
    Likes Received:
    0
    No need for a resistor.
     

Share This Page