1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Electronics Can you check this schematic for me please?

Discussion in 'Modding' started by g0th, 24 Apr 2005.

  1. g0th

    g0th What's a Dremel?

    12 Apr 2005
    Likes Received:
  2. One~Zero

    One~Zero What's a Dremel?

    9 Sep 2004
    Likes Received:
    Have you tried breadboarding this yet? I was working on a circuit that utilizes some of the same logic as yours (entirely different circuit though) and found that I was getting a 1.2-1.8vdc "floating" around the clear pins for the 74ls393n. I had to use a pull-down of about 1k to get rid of it. At approximately 1.3vdc on the clear pin, it was just enough to keep it in a constant reset state, and it wouldn't count. I would be interested to see if you ran into the same problem.

Share This Page