Discussion in 'Modding' started by cpemma, 30 Dec 2005.
I love the R2D2 mod, what kid wouldn't kill to have that in their room.
Nice setup, i just finished my PC modded Desk, i hope you guys like it http://www.youtube.com/watch?v=gLw6HvIGaWY
That R2D2 mod... well done man!
Thank you very much for your knowledge of this all for me
I have a CaseLabs S5, and as some of you know, its 100% aluminum. I need make some screw holes in my S5 to attack a res to the side. My question is how would i go about doing this? Im following http://www.youtube.com/watch?v=tng-40zrUY0  and can i just go from the initial screwing of the small thing from the machine screwdriver to just slowly screwing the final screw i want in?
Or does it not work like that
Or is there any other method?
not sure what to do with grill/venting for GPU area
Top and bottom panels either going to be redone via full 3d print or small section created. Gaps at the side with Metal mesh
was either thinking hole cut roungly size of 280 aio with metal mesh or 280 rad grill panel in metal with magnetic silverstone filters on the inside ...
Separate names with a comma.