Graphics Crossfire = No DVI Display?

Discussion in 'Hardware' started by strife045, 17 Jun 2006.

  1. strife045

    strife045 What's a Dremel?

    Joined:
    17 Jun 2006
    Posts:
    2
    Likes Received:
    0
    My ViewSonic VX922 LCD does not show a display at any time (POST to Windows) when using DVI input. It does work when the DVI is converted to VGA. The LCD works on DVI and a Samsung LCD has also been tested on DVI. Crossfire has been setup correctly and does work.

    System:
    FX-55
    A8R32-MVP Deluxe
    X1900CF
    X1900XTX
    2048 OCZ Plat 400
    4xRaptor 74GB RAID0
    Audigy 2

    Why would it only work converted to VGA? The monitor and crossfire dongle both use DVI-I; I have tried both DVI-D and DVI-A cables. Either one of those should work.
     
    strife045, 17 Jun 2006
    #1
  2. ch424

    ch424 Design Warrior

    Joined:
    26 May 2004
    Posts:
    3,112
    Likes Received:
    41
    On the monitor, press the 1 button, then scroll down to Information and press 2. It should say something like:

    H.Frequency: 64.00 KHz
    V.Frequency: 60.00 Hz

    Does it?

    ch424
     
    ch424, 17 Jun 2006
    #2
  3. strife045

    strife045 What's a Dremel?

    Joined:
    17 Jun 2006
    Posts:
    2
    Likes Received:
    0
    H 60.08 KHz
    V 60.14 Hz
    Pixel Clock 108.15 MHz

    The monitor menu only shows on Analog input.
    Using DVI nothing is displayed; the power button goes from green to yellow. This happens when in the BIOS or in Windows. From POST on there is no display on DVI at all.
     
    strife045, 17 Jun 2006
    #3
Tags:

Share This Page