Electronics cutting pc/matrix/strip board

[cream egg advert] how do u do yours? [/cream egg advert]

i have used craft knife (slow but no dust), hacksaw blade (some large dust), dremmel (fast & lots of fine dust) and i used a face mask

the dust is nasty but the craft knife takes ages to do so i havent decided on the best yet used a guillotine at school that ruled but i cant afford one

 

I just run a stanley knife accross it once then snap it. It snaps perfectly every time.

 

it always snaps unevenly 4 me

 

try doing a few strokes (hard strokes) with the knife, to get a deep start off, then snap.
or try running the knife on both sides, then snap.

 

Junior hacksaw, saw along the holes, copper side up

 

I use the dremil

Just make sure to wear a dust mask, as that stuff will clog up your lungs and probibly take a few years off your life

 

its just i do must stuff in my room so its a pain to go outside to cut a pcb then come back in

looks like a craft knife jobbie then