1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Modding External Power article help

Discussion in 'Modding' started by LiL_MJ, 25 Jul 2004.

  1. LiL_MJ

    LiL_MJ New Member

    Joined:
    4 Nov 2003
    Posts:
    109
    Likes Received:
    0
    Hi im planning on doin this mod but not too sure about the parts need as i cannot find them in maplins.
    was wondering if anybody has tried this mod and could supply some codes from maplins of which i need.
    i c on the article the parts were purchased from Rapid Electronics but i have a maplins down the road so prefer to pick up :)


    thankyou


    http://www.bit-tech.net/article/76/
     
  2. inzane86

    inzane86 engineer with an axe

    Joined:
    15 Jan 2004
    Posts:
    105
    Likes Received:
    0
    If it's so close then go down to the shop and ask for the things u need. Why do you need codes for that? If you cat memorize them write them down.

    3 x 2.5 mm DC Power Socket(it doesn't have to be 2.5mm pick the size you like best, and a suitable plug)
    1 x 5.25" Disk Drive "Y" splitter power cable
    1 x PCI cower... look at the back of your pc... :idea: or try pouting the sockets in a different place... in a floppy cower for example. :thumb:
    Heat shrink insulation ask at the shop.

    And happy moding :dremel:

    sry if my spelling is bad.
     
  3. RaptorRed

    RaptorRed New Member

    Joined:
    31 Aug 2003
    Posts:
    107
    Likes Received:
    0

Share This Page