Hello people, the "FC8-Fine" is my current project This is a passive cooled HTPC has kindly provided Streacom disposal. Thanks again for the beautiful may I rebuild the case. In the front is a display and a small gap to be milled. In the top of my logo smoke gray plexiglass will find its place. More to me is not yet occurred, but I will leave it plain. He is said to ausschauen after my editing. I'm always working on liver via webcam online LiveModding Center First Update: It checks the Case from out of the box ... Then it started already with the disassembly. The front is screwed on with three screws from the bottom. This is the beautiful display that will come in the front. In the front is smoke-gray acrylic glass. As you can see it glows well. Unfortunately I had to find it all a little too closely. The law, the board of the front panel. I hone therefore the board must be more than 2.5 mm. The final depth of which I have honed my sadly lacking a picture ... forgot to make When that was settled, I could begin to cut out the front. Perhaps this is tough stuff ... : D First few holes drilled ... ... and then cut with a jigsaw and filed nicely. Then I Ahbe the part given to a piece of Plexiglas, torn with the scriber, cut out and then filed. I'm pretty slow when filing sampled ran to the opening in the front. Then I was able to knock it in with a hammer. I have it but then again taken out, filed the edges gradually colored with a black marker. Then again, so pure. To fix the screen I've used t-nuts. ... But since had to have a UNC thread only times a 3mm thread cut on it. If everything is pressed pretty full. And between the display and some plexi is in the air, because the USB connectors disturb ... ... so I then glued some foam, which comes as no dust behind it. Here you see the reason I could not go up with the display. The upper one is the holder for LW and HDD. The press fit is everything, as any hands between LW top and front panel goes down. So it looks then finished. Now missing from the top or the logo. Let's see if I still what comes to mind. here's a video of the operation of the display http://www.youtube.com/watch?v=VBjejRw_pig Ubdate two: I've forgotten at the last update or something. I have provided a motherboard from Sapphire for the case. But it did not think it could be compatibility problems. Therefore, the fit is not now. I need a board for the case with FM1 base. And since there are only 2 in the list are the comparator, an Asus and Gigabyte . Here you can see quite nice because it does not work with the heatpipes. Well, I'm just looking at whether I get the Asus. Well, now wait. Do I have time over the logo produced, I thought to myself. So logo on printed paper ... ... with crepe tape and then taped the case painted wood glue ... ... the paper pasted on it ... ... cut drilled some holes and slots with the Flex purely as 7.5 mm holes have not been enough for the jigsaw blade. For cutting I have secured a thicker wood to the table and then to the plate. Then cut with a jigsaw ... http://www.youtube.com/watch?v=S7HlTYNSvJc The edge I have again blackened with a marker, then they are not visible through the Plexiglas. I then put the lid on the plexiglass and touched with a needle rice. Update three Fail from Logo Cut. http://www.youtube.com/watch?v=PCQRencd1Ak&feature=g-u-u&context=G252c2c3FUAAAAAAAAAA"