1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Help: Custom Manufacture F360

Discussion in 'Modding' started by Ramon Ruperto Villalon, 5 Nov 2020.

  1. Ramon Ruperto Villalon

    Ramon Ruperto Villalon What's a Dremel?

    Joined:
    5 Nov 2020
    Posts:
    2
    Likes Received:
    0
    I need help with Fusion360 in manufacture section. I'm having trouble with fillet of 4mm which I am currently new with F360 or AutoCAD.

    upload_2020-11-5_10-48-38.png

    upload_2020-11-5_10-50-37.png

    Can't figure it out what tools to use on D5 impeller cavity. I hope you could guide me. Thanks.
     
    Ramon Ruperto Villalon, 5 Nov 2020
    #1
  2. Cheapskate

    Cheapskate Insane? or just stupid?

    Joined:
    13 May 2007
    Posts:
    12,427
    Likes Received:
    1,989
    4mm ball end mill?
     
    Cheapskate, 5 Nov 2020
    #2
  3. Ramon Ruperto Villalon

    Ramon Ruperto Villalon What's a Dremel?

    Joined:
    5 Nov 2020
    Posts:
    2
    Likes Received:
    0
    @Cheapskate, not the drill bits. My main I couldn't get the same results from the simulated manufacture in 360. I'm not quite familiar with F360.

    upload_2020-11-6_7-38-54.png

    If you could guide me with the tools, i would appreciate it. Thanks
     
    Ramon Ruperto Villalon, 5 Nov 2020
    #3

Share This Page