1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Modding How would I hook up a CU20025SCPB-T20A VFD

Discussion in 'Modding' started by error.ini, 10 Oct 2003.

  1. error.ini

    error.ini What's a Dremel?

    Joined:
    25 Aug 2003
    Posts:
    23
    Likes Received:
    0
    http://www.qscomp.cz/Pdf/CU20025SCPB-T20A-05.pdf
    I bought this VFD above, and was wondering if I could hook it up to serial? Serial is only like 1 wire, which would be ideal for where it's going to go. Can someone tell me which pin (if any) can hook up to serial?

    1 more, thing, it seems to have 2 different places to power it, 1 is like a 3 pin fan header, can I just use that source for power, and not the VCC with the 16 pins?

    Here is an image of it
    [​IMG]
     
  2. pranks7er

    pranks7er mange tout

    Joined:
    25 Dec 2002
    Posts:
    3,515
    Likes Received:
    0
    go to LCD FAQ in electronics check there :D
     
  3. error.ini

    error.ini What's a Dremel?

    Joined:
    25 Aug 2003
    Posts:
    23
    Likes Received:
    0
    The pin setup is different than it shows in the VFD serial review. On Noritake's website says "This
    can be RS232 for POS, RS485 for transportation and
    8 bit parallel for instrumentation.", but on all of the guides, I see different names for pins.

    *EDIT* - It seems that it's only a parallel, but still, some pins don't match with what I see in the guides. Thanks.
     
    Last edited: 10 Oct 2003
  4. dario87

    dario87 What's a Dremel?

    Joined:
    16 Oct 2009
    Posts:
    1
    Likes Received:
    0
    display CU20025SCPB-t20a

    hi I´m German Dario Ordoñez. i need to replace a CU20025SCPB-T20A. and i want to Know if you could sale it me or tell me about someone that could do it.
    no mather if it is used. only the cheeper.

    if you can to help me whit this. i'll be thank you.

    please write me to darioordonez@hotmail.com

    best regards
     

Share This Page