Discussion in 'Hardware' started by OZiRiS, 26 Nov 2004.
i have solved my problem thX!
How is your router going to know where to direct traffic to if you have the same port directed to more than one IP address? Surely if you are hosting the game, you only need to map the port to the IP of your server?
Firstly I would say to set your computers IP to a static address, so when mapping the ports the IP won’t change next time u boot up. Make sure you set the gateway to the IP of the router and then give it a few minutes for the changes to take place.
Remove all the port forwards you have now and put these in:
1 6112 6112 TCP X.X.X.X
2 6112 6112 UDP X.X.X.X (X’s being your now static IP)
Also with games you usually find that it will open a new port for each gamer (I know it does for CoD) so i would do the same for other port ranges such as 6113, 6114.
EDIT: I looked on a few warcraft web sites seems you only need to open the 6112 port
ok when i type INCONFIG i get the following
then u get ur IP's
tried it with just TCP and it didnt work , will try now with both
even when i forwarded TCP and UDP it still didnt work, so it must be some otehr setting on my routers.
WHat else can cuase problems hosting so i can play around with the danm thing
do you have SP2 Installed? If so it may be an idea to turn off the windows firewall (in control panel) & see if that sorts out your problem.
what ip address do you give out to the other people becasuse it should go
with what ever ip your isp is giving you lets use this as an ip 220.127.116.11
you tell them to use this 18.104.22.168what ever port you are using)
also then you user port forwarding use the ip address the router is giving (i am going to try and explan this the best i can) but say your router giving you the ip of 22.214.171.124 use port forwarding so that port 21 goes only to the ip 192.168.1.1 so then you give the ip of your isp out it will only go to your computer
so after typing that IPCONFIG
Also i have SP1 and as i sed all firewalls are off.
ALso i red some where it might be my NAT settings?
my NAT settings is = DYNAMIC NAPT
ALSO i have changed my war3 ports in game to 6113 and and did the same as above only with 6113.
this si how i did it on my linksys u need 2 do prots 6112-6119 enable udp and tcp and only do it 2 ur router ip ok if u do it 2 multiple it wont work
SO which is my router IP?
is it the IP i use to access my routers configurations?
when i typed IPCONFIG in my post above which one of those IP's should i use?
Is it risky giving out all these above information?
even when i set my DMZ on and host ip as my internal one i still cant host
Separate names with a comma.