Hey, I just started a new mini project a few days ago to replace my aging 120w modified ATX PSU that I was using for testing items requiring molex power. I got this nice 200w AT model that I had no use for, and it has a fair amount of room inside for switches and things so it fit the bill. List of mods being done; -Mounting toggle switch -power indicator LED -Wire terminals -Molex mounted in PSU case -possible paint if it needs it -possible window (and therefore more LEDs) So far I've ran into a few snags. Radioshat had a nice little set of wire terminals I thought, but when installing them they kept coming loose from the case when I tried to turn the plastic tops, and while super-tightening them one of the bolts sheared off at the base. Then later after wondering why the PSU wouldn't turn on anymore, I find out that the terminals all are shorting to the PSU case. Apparently they aren't made for being mounted in metal, but that was never written on the package, and it said they were insulated. I may be able to fix this problem with some larger holes and some hot glue though. Other than that everything has gone well. Nearly wore out my needle file set though making the molex holes fit perfectly and be rectangular. ^ Trimming the wires back and discerning what I do and don't need. ^ Poor-quality terminals (before being broken) ^ The molex holes nicely cut out ^ PSU reassembled for a test ^ Molex connectors held in place by friction, I'm not gluing them in until I decide about painting the case. ^ Just another shot. Since then I've added a green LED right above the toggle switch in a small LED holder. More updates soon! *PS* Thoughts on a colour?