1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Modmytoys Fan power Distribution block

Discussion in 'Watercooling' started by J-Pepper, 15 Apr 2014.

  1. J-Pepper

    J-Pepper Minimodder

    Joined:
    20 Jul 2004
    Posts:
    1,482
    Likes Received:
    3
    Obtained one of these to help control all my fans in my current build. Gives it a cleaner look so i don't need a fan controller, and it can be controlled using software.

    But i'm a little confused, albeit a nooby question. Am i right in saying that for one of the fan pins, i'll need to attach a Y splitter where one end will go into the mobo fan port and the other to a fan, then the remaining fan ports for fans... so

    Fan pin 1: Y Splitter for mobo and 1 fan
    Fan pin 2-8: remaining fans
    Molex: to power the board

    It's one of these

    [​IMG]

    All of my fans are 4pin pwm connectors
     
  2. Big Elf

    Big Elf Oh no! Not another f----ing elf!

    Joined:
    23 Apr 2009
    Posts:
    3,672
    Likes Received:
    323
    I'd expect it to have a feed for a 4 pin PWM header if it could be controlled by PWM. I could be wrong but I think you need something like the Swiftech PWM splitter to be able to control and report RPMs for PWM fans (or pumps).
     

Share This Page