1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Modding Molex Pin Extraction (female)

Discussion in 'Modding' started by TwiSteD LoGic, 20 Jan 2004.

  1. TwiSteD LoGic

    TwiSteD LoGic What's a Dremel?

    Joined:
    1 Nov 2001
    Posts:
    176
    Likes Received:
    0
    I was just wondering if anyone had a good method for removing female molex pins from the plastic pieces w/o spending 15 bux on a molex pin extractor.

    Thanks alot. =)
     
  2. The_Sub

    The_Sub What's a Dremel?

    Joined:
    16 Nov 2003
    Posts:
    281
    Likes Received:
    1
    Use a paper clip or a really small screwdriver to bend in the little tabs just a bit. The wire should just pull right out of the connector..
     
  3. TekMonkey

    TekMonkey I enjoy cheese.

    Joined:
    6 Dec 2002
    Posts:
    3,081
    Likes Received:
    0

Share This Page