Cooling Mounting a BIX/BIP 3 in a Lian-Li 6077

I'm after a Lian Li PC-6077b and hoping to water-cool it, but there are two issues that i have.

1). Where can i even find one of these cases?
2). is there enough space along the bottom for a rad (not fussed about lossing a load of PCI slots, as i only realy need 2 or 3) without cuttng out part of the drive bays? (seeing as the rad is 120mm wide, and 15cm or so wide, a little like http://forums.bit-tech.net/showthread.php?t=98605&page=4.


AJ.

 

I looked everywhere for one of these cases my self, I finally found a store (eclipse computers) but their silly stock system is all wrong and they didn't actually have any and I doubt they ever will - PC6077/b's are now discontinued. So the only way I think you'd get one is by finding one second hand on eBay or Forums...

Also looking a Scampi's mod the only thing obstructing the bays is the AC grill, or he might have rad quite far away from his mob, either I doubt it's too much trouble, I got a BIP 360 in my CM stacker fine

 

The only 6077 case i can find is on xoxide.com and only in silver.Too bad if you live outside of the US.
If i couldnt find 6077 i'd go for
V1100B or
V600B
check them out

 

I just remembered that lian li did make a new case that has the same characteristics as the 6077: The A16: http://www.lian-li.com/Product/Chassis/Middle_Tower/Classical_Series/M_C_S_PC-A16.htm it's basically the same chassis as the 607 but it has different removable mobo tray and meshed bay covers.