Okay, I have been planning this for a long time (well about 6-7 months now). My idea is to make a "computer". Let me explain, I want to build a "computer" with a micro controller. My plans are to use a combination of point to point soldering and wire wrap. I want to mount this on I assume what is perfboard (board with many holes and no conductive stuff on it). I plan to use a PICAXE 18X. I want to implement a expansion bus, with an array of maybe 2-3 edge connectors. I would use a ULN2803A darlington driver between the edge connector and the micro-controller correct? I also plan to put on another different pin size edge corrector to contain the eproms for software. I am also planning to stuff this whole board in to a normal computer case. I haven't really spent much time looking in to the circuit for the eprom, The one I am looking at is the 24LC512 made by Microchip, because I know of another guy who used to one with this microcontroller and it seems to be able to suit my fine. I want to construct a circuit on a small 2inx.5in perfboard, which will contain 4 of these, what is required for this? Does anyone know of what I would need to get VGA out of this micro-processor?