Small Form Factor need advice with mobile barton and SNG412

Discussion in 'Hardware' started by mad2moons, 28 Apr 2004.

  1. mad2moons

    mad2moons What's a Dremel?

    Joined:
    8 Feb 2004
    Posts:
    119
    Likes Received:
    0
    Bought a mobile barton 2500+ and put it in my shuttle, yet its picking it up as an unknown CPU @800mhz 266. Bumped it up to 333 and still only get 1000mhz.

    Any help please??
     
    mad2moons, 28 Apr 2004
    #1
  2. Pinda

    Pinda What's a Dremel?

    Joined:
    28 Apr 2004
    Posts:
    4
    Likes Received:
    0
    what about setting ur multiplier
     
    Pinda, 28 Apr 2004
    #2
  3. mad2moons

    mad2moons What's a Dremel?

    Joined:
    8 Feb 2004
    Posts:
    119
    Likes Received:
    0
    no multiplyer setting in the bios :(
     
    mad2moons, 28 Apr 2004
    #3
  4. Pinda

    Pinda What's a Dremel?

    Joined:
    28 Apr 2004
    Posts:
    4
    Likes Received:
    0
    mayb u have to do bios update..
    my v2 bios is cpu ratio or something there to set multiplier
     
    Pinda, 29 Apr 2004
    #4
  5. cderalow

    cderalow bondage master!

    Joined:
    23 Jan 2002
    Posts:
    3,519
    Likes Received:
    0
    indeed the mobile bartons only have 266MHz fsbs to start with, so by going to 333, you've technically overclocked it a lot....


    technically your board is set to 266x3 at default with it, so if you go into your bios into ratio/voltage control, you should be able to adjust the multiplier there.... not sure what the proper multiplier is, ask bigZ or yodasarmpit for more info as they both run mobile cpus


    though i might do that same soon for the sake of keeping 1 pc system
     
    cderalow, 30 Apr 2004
    #5
Tags:

Share This Page