1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Motherboards P8Z68-V Pro Boot_Device_Failure

Discussion in 'Tech Support' started by Lord Xeb, 11 Nov 2011.

  1. Lord Xeb

    Lord Xeb Derka Derpa Derka Derp

    Joined:
    7 Jan 2010
    Posts:
    176
    Likes Received:
    22
    No matter what I do, I cannot get my computer post and all it does is stop at Boot_device_failure LED. I have done the following:
    Cleared the CMOS
    reseat the ram (even moved the slots and played with one then the other in all 4 slots)
    removed my graphics card


    I really cannot thing of anything else that will cause this.

    No external hard drives or anything are connected either...
     
  2. SuicideNeil

    SuicideNeil New Member

    Joined:
    17 Aug 2009
    Posts:
    5,983
    Likes Received:
    345
    Try the HDD on another socket, or pull it completely just to see if it will post that way.
     
  3. Lord Xeb

    Lord Xeb Derka Derpa Derka Derp

    Joined:
    7 Jan 2010
    Posts:
    176
    Likes Received:
    22
    Already did, and it won't
     
  4. SuicideNeil

    SuicideNeil New Member

    Joined:
    17 Aug 2009
    Posts:
    5,983
    Likes Received:
    345
    Got a different HDD & PSU to test with?
    I'd say try building it outside the case but I doubt that will make much difference ( if it was shorting out on the case it would do it when you built the system to start with )- sounds more like either the mobo or psu has croaked it unfortunately...
     
  5. Lord Xeb

    Lord Xeb Derka Derpa Derka Derp

    Joined:
    7 Jan 2010
    Posts:
    176
    Likes Received:
    22
    It turns out it was the mobo. I tried EVERYTHING I could think of and just gave up. Took the board back to MC and replaced it with a new board (the UD4 ^_^) and what do you know. Thing works.
     
  6. Guest-16

    Guest-16 Guest

    :(

    You killed the PCH then :/
     

Share This Page