I know I'm a nub here, but I've done some mods before, actually I just had my Project: Hive Mind featured in the latest PC Modder Mag, I'll make a post about that in the Gallery. Anyway, after creating a textured exterior, I wanted something simple, yet stylish for LANs, so I'm making Bebop, a case themed after the Cult Classic Cowboy Bebop. Its an anime.. The Case is a Cooler Master Centurion 2: The Rear: Close up of the Front: The Chasis: I cut 4 holes in the chasis. Cutting alloy is 100 times easier than cutting a steel case. My dremel went through this case like butter! It was so easy! Front 12cm hole: The Back, where the old 80mm was. The Bottom of the case: The Mobo panel: Next thing is to drill the holes for the 120mm fan, grind all the cuts, and get some rubber grommats for the holes. I might cut up the chasis a little further, I'm not sure. Note: That all the cuts shown have yet to be grinded down. Heres what I have planned for the exterior: I like what I've got sofar, but I want to encorporate Ein and Ed into the front. I'll see what I can come up with, but it'll probably be some sort of stencil over the front, done in Hot Pink or a Neon Purple. I’ve already started to lay out the complicated dremel work on each of the side panels. Here is Jet on the top panel. Here's the more complicated cut of the three planned thus far: Spike. And just to show you guys how I made the outlines, these are the stencils I used, which I made using Photoshop. I’m open to comments and suggestions, but as it stands I think this case is almost written in stone, design wise.