1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Project Blacklight Demons (plexi fulltower)

Discussion in 'Project Logs' started by [WP@]WOLVERINE, 11 Dec 2003.

  1. [WP@]WOLVERINE

    [WP@]WOLVERINE New Member

    Joined:
    18 Oct 2003
    Posts:
    470
    Likes Received:
    21
    Ah i missed that one :) But now ive seen it and it looks good :) The only thing i can say is that you should use a different etching bit to get even better results.

    I use theese for plexietching
    [​IMG]
    Examples:
    One made when i was bored
    [​IMG]
    Sidepanel for the BLackligth Demons case
    [​IMG]

    And i use various diamond etchingbits for etching on metal i dont have any pics of theese etching bits but they come in all shapes and sizes.
    Examples:
    Sidepanel on a Antec PLusview 2 made for Antec as a prize in a giveaway at Dreamhack
    [​IMG]
    Sidepanel on an Lian Li pcv1000 from my article here on bit
    [​IMG]
    http://www.bit-tech.net/modding/2005/08/01/star_wars_etching/1.html
     
    Last edited: 2 Dec 2005
  2. Klekkus

    Klekkus New Member

    Joined:
    5 Nov 2005
    Posts:
    765
    Likes Received:
    0
    Thanks

    Nice engraving :thumb:

    I'm gonna buy a flexi shaft and more engraving bits for xmas :D

    Edit:
    Are there big difference to engrave on plexi and lexan?
     
  3. [WP@]WOLVERINE

    [WP@]WOLVERINE New Member

    Joined:
    18 Oct 2003
    Posts:
    470
    Likes Received:
    21

    PLexi is just the brandname its actually Acrylic
    The main difference is that Lexan is harder and more scratch resistant wich means that you can run the dremel at a much Higher rpm than you can on the softer Acrylic. But Lexan costs a bit more but if youre building a whola case the lexan is definetly best.
     
    Last edited: 3 Dec 2005

Share This Page