Hey friends. Already set the feet of the case, has four layers of paint. I've put a rubber and neoprene to prevent vibration. Here the feets installed in the case. At the front they have put a bar of aluminum feets to prevent it rotating rods are fixed in the cylinders. I've set the bar to the feets with screws M3 x 12 mm. Here are the front feets are only attached to the cylinder rod, travel is 55 mm. As you see the feets are tilted to either side, and with increasing remain case accented legs flat on the floor/table. Now a few pictures of the case in the table. The case raised to 55 mm. Regards.