Discussion in 'Project Logs' started by ColdzeroTeam, 9 Dec 2010.
What are those 4 fittings for, seem like they are going outside the case...
looking real tight!
Probably the routing of the two radiators in/outs (four in total) They are going outside with tubes and then back into the case a little higher where (see plexiglas in/outs)
correct me if I am wrong about the above.
you got that right
Hope you like it ^^
One word. WOW!
Looks good man!!!
Such a nice tidy build.
If that really is the Serial bridge, your card setup won't work
Other than that, nice work
Thanks Every one
Yes they are working this way ^^ why do you say that?
The cards wont work because?
This project is already finished in Portugal , one of the best his team has done , the computer is already at his owner house and working but Patuga or Dyabinho the members of this team can corect me if im wrong ;D
Have a look at the following picture:
Link to Pic on EK Website
In your case, the water enters the brigde on the bottom, flows only through the lowest card, and exits the bridge on the other bottom port. No flow for the middle card or the card on the top
Ahhh... eu falando em inglês e não tinha percebido que esse lindo projeto era de um time de nosso amigos portugueses
Ótimo trabalho, essa caixa está simplesmente explêndida!!!
Parabéns a todos desse time, maravilhoso trabalho!
Grande abraço a todos vocês e um ótimo ano novo!
Bridge is modded to paralell . because yes, it would not work like that in serial
Can't wait to see this finished
so far that looks stunning!!!
Really 'clean' !!
lots of modding rep!
That ek sli block looks really clean!
Love the idea of the water pipes out the front as well. Keep up the good work.
Some gorgeous kit you've got there pal and some awesome mod's to house it all, top stuff!
Separate names with a comma.