Hello again guys! I was not planning another build, but after talking a bit to a guy going under the nick FabsSPeed, we decided that he needed a not so ordinary primary PC. So, without much jibberish, let me introduce Project N.V. - A caselabs TH10 FabsSPeed edition N.V. will be a caselabs build, and this short introduction will leave some to be desired, you see I forgot my DSLR at home BUT! This will be a mad overkill build and lots of parts will be machined with help from Nate, known by most as Editor22, and 3D printning might occur The obligatory hardware list: A cpu, a motherboard, a case and some power to run it all. Grafic cards might be added, while harddrives will most likely be found some where. But lets get startet! First of all, lets start out with this lovely box. What might it contain? What madness is this? A US made woman! Naah, just kidding. As I said, my DSLR is at home, so you will have to do with some mobile shots for now But lets have a look at some of the hardware that will be used. CPU Mobo The wonderful controller that will keep the 24 fans this system will use busy! And a small teaser of one of the reservoirs. Some of you might recognize this from my M8 project, but do not wory, the front reservoirs will be bigger and better than the ones in M8 And just to give you a little taster of what I will be focusing on in this project, I present you with a modded version of the EK-RAM Dominator X4 CSQ blocks that will cool the ram in this build: That should keep Nate busy for a few hours I only need a few more parts, and then I can complete that thing, and get it fabricated! Deadline for this monster will be: Finish before Pascal AkA Paslis A great thank goes out to the sponsors of this project! Its ON!