1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Case Mod - Complete #Pure sponsored by Thermaltake and MSI

Discussion in 'Project Logs' started by AML_customs_pc, 26 Mar 2019.

  1. AML_customs_pc

    AML_customs_pc Member

    Joined:
    24 Feb 2017
    Posts:
    108
    Likes Received:
    24
  2. AML_customs_pc

    AML_customs_pc Member

    Joined:
    24 Feb 2017
    Posts:
    108
    Likes Received:
    24
    Hey, hope everyone had a good weekend.


    So this is the case,


    [​IMG]


    [​IMG]


    I remove psu cover and motherboard tray.


    [​IMG]


    I made a model out of cardboard to make sure I got the correct sizes for the perplex


    [​IMG]


    After I did this I removed the IO shield and graphics card supports from the back of the case so I can move this to the top of the case.


    [​IMG]


    [​IMG]


    [​IMG]


    [​IMG]


    Once I cut the case up I new I would need to replace the back of the case, I made a quick design on fusion 360 and made a new back panel, this will include displayport and 2 usb 3.0.


    [​IMG]


    [​IMG]


    I chopped down an old bracket for the thermaltake p3 to help support the graphics cards so it can hang down in the case.


    [​IMG]


    This is the point I needed to stop as I needed to pick up the perplex for the next stage of the project.


    This is where we are up to.


    [​IMG]
     
    arduum likes this.
  3. AML_customs_pc

    AML_customs_pc Member

    Joined:
    24 Feb 2017
    Posts:
    108
    Likes Received:
    24
    This week I made the the custom motherboard tray with built in res, I used 10mm acrylic to do this.


    [​IMG]

    the start of the motherboard tray.

    [​IMG]


    [​IMG]

    [​IMG]


    Making the motherboard res.

    [​IMG]


    [​IMG]


    [​IMG]

    Test fit with the motherboard.

    [​IMG]

    Need to add the custom o-rings

    [​IMG]


    [​IMG]


    [​IMG]

    Wanted to see what the water manifold would look like with some water in.


    [​IMG]

    I will be down I64 this weekend so this is where I will stop for this week. You can see its starting to take shape.


    [​IMG]

    next post we should have the cables the covers and the tubes ran.
     
    Cheapskate, Lambda and arduum like this.
  4. AML_customs_pc

    AML_customs_pc Member

    Joined:
    24 Feb 2017
    Posts:
    108
    Likes Received:
    24

Share This Page