1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Modding Short dual IDE cable

Discussion in 'Modding' started by Longtalltechsan, 28 Oct 2005.

  1. Longtalltechsan

    Longtalltechsan What's a Dremel?

    Joined:
    5 Oct 2004
    Posts:
    96
    Likes Received:
    0
    Anyone know if or where you can get a dual IDE cable that is shorter than 18"? I have looked at most of the online retailers I know of and the shortest I can find is 18". I'd like one in the 10" range if anyone knows. Thanks.
     
  2. customh

    customh conflagration.

    Joined:
    22 Oct 2005
    Posts:
    2,590
    Likes Received:
    1
    One CAN shorten an IDE cable, takes a little work but hey, this is a modding forum, isnt it? Heat shrink it the same color and away you go.
     
  3. Longtalltechsan

    Longtalltechsan What's a Dremel?

    Joined:
    5 Oct 2004
    Posts:
    96
    Likes Received:
    0
    Yeah I knew it was possible for one to do it themselves, but I was really hoping to not get into that. With all the small pc's out there, surely someone has made, or mass produced rather, a shorter one than 18". At least I am hoping.
     
  4. Smilodon

    Smilodon The Antagonist

    Joined:
    25 Mar 2003
    Posts:
    6,244
    Likes Received:
    102
    it's probably easier to shorten an IDE cable than finding one in a shop.

    just search for a guideand practice on some old cables.
     
  5. Firehed

    Firehed Why not? I own a domain to match.

    Joined:
    15 Feb 2004
    Posts:
    12,574
    Likes Received:
    16
    Shortening a rounded one would be near impossible. If you can put up with a 40-pin flat one, it's not too hard. 80-wire is notably harder but still doable. I've seen a 6" single-device. I don't think you're going to find a commercially-produced dual-device IDE under 18".
     

Share This Page