Hi there, As part of my next project, I'm going to be accurately modeling a load of components. I'm using Autodesk Inventor and Blender so won't be exporting them as sketchup files, but I know that Sketchup can import .stl files fine so I'll use those (plus they work very well in other packages too) So first up is an XSPC EX360 Crossflow Radiator Download link (via Mediafire): Here Warning: This is a very high poly model (~140k polys) as all the fins are also geometry. It's as accurate as I could make it, all the measurements were made using calipers on an actual EX360 rad. The model may need to be scaled depending on which program you used. I scaled it down by a factor of 10 when I imported into Blender from Inventor (I made the fins in Blender). So you may have to scale it up by 10 when importing it, not sure on that but it should be obvious enough, just bear in mind that it's going to be factors of 10 out in terms of units if it's not correct.