some progress I make a detail to a main gear I covered the plate that was cut then the putty, sand, putty and then I went back to sand Then I continued with the creation of the chimney I joined the bays of the front and place a wood to where the fan. and finally paint the brass . It's all for now, is not much but each piece takes many hours of work, thanks.
thanks I continue with the side, which was painted after the repair and followed with the design of the logo, which is placed behind an acrylic and decorative screws, as also painting the frame and gears, the poster of the asupiciantes, which was drawn with fire, the shield of ArgOs, which is composed of 5 pieces, and is more than 90% over the side. Poster sponsors Shield of ArgOs Full side (so far) I paint it black the acrylic and before you ask, why I cut it and then I put a acrylic paint it black and its not as if I had done nothing, after so much work?, simple, it will be illuminated from behind.
thanks Cheapskate. In this time I spend to the front, the logo of Sentey transorfm chrome to bronze, because chrome is not used in the Steam (usually), as to the buttons on the reader and digital commands were painted copper . I began cover some parts of the front with wood and I painted bronze bottom. Thank you very much, this weekend there will be more progress.
I'm liking where this is going. Nice fill job on those holes! A lot of steampunk stuff goes way over the top, but this is looking really well thought out, with great attention to detail.
Ohh Parge, what do you see? ha ha ha ha One side is practically finished, but I can not get small gears for the world logo Like the front with almost every detail, I put the screws and some decorations as the design. soon the other side and the inside
Its, so, Steampunky! That's a word now, a word to describe the epic-ness of this case mod. Good work and I look forward to seeing the final steps done, to complete this masterpiece!
