Modding water cooled Lian Li

project water cooling complete, well......almost.





all i need now is a fan controller to tame that beast of a panaflow currently at 12v pushing 103.8 CFM@2400RPM with a shocking 41.5 dba

Temps: Idle 32 degrees C
Prime 95:47C (amb.23)

 

Update

added a small fan to voltage regulators n covered up the mobo power connector with some shrink wrap and black tubing

 

get some dye in those tubes!!

 

I'm confused why would you put A tee in a watercooling loop? from what I can make the pump goes straight to the cpu block then tee's and after that it gets hazy I could see using a Y to halve the pressure but double volume but a t would just descrease the flow rate to everything

 

isnt the t allowing him to use a fill tube, which is just coiled up, up there.