Cooling water temp problem(i think!)

hi,

i have just set up a new computer and i think i might have a problem with
the temp of the cpu, or mbm is telling me a load of poop!

mother board=chaintech 7njs ultra 400 n/force 2
cpu=amd 2800 barton(166 fsb)@200x11=xp3200
2xcorsair 512meg(1 gig) 3200LL
radion 9700(non pro) no overclock....yet
2x 120 gig maxtor d/max 9
120 mm rad(2x120mm fans)
danger den maze 4 cpu block
danger den "z" chipset block
danger den maze 4 gpu block
half inch tygon hose all round
hidor L30 pump
480 watt eps12v psu
artic silver 5 on all blocks

my temps at idle are 41c-46c and full load can go as high as 50c, this to me is WAY to high i have heared that the barton cores run hot but given the flow rate of this set up this looks to high to me.
any thoughts....................................

thanks
fluf_art

 

Deepends on where its getting those temps, I have a gigabyte motherboard,with 2 different temps monitors for the cpu, one is the diode inside the processor itself, and a temp probe thats seprate. Also, don't always trust the built in sensors, they are not always very accurate.

 

problem solved!

it was me!!! i spoted this link http://forums.bit-tech.net/showthread.php?t=56879. i put way to much water weter in and the water had foamed up
so i have flushed it all out and all is ok!!!!

thanks

fluf

 

yeh pmsl sorted the problem and blew up his gf card in the prossess u tit lol