Cooling watercooling setup help

well since i dont seem to get any more answers for my old thread heres a new one can some one show me how to conect a watercooling kit together that has two resviors

 

pump-rad-blocks-res top-res bottom-pump

 

Hi i would do the following

RES***RES
|*****|
Pump***Pump
|******/*\
CPU***GFX GFX
|******\*/
Voltage***North
Block*****Bridge
\****/
RAD
/***\
RES***RES​

 

I don't know where your old thread is, but I'd basically do as above, but have the GPU blocks sequential. Having a Y fitting to split flow is asking for problems - uneven flow is created, and there's always a chance that you'll end up with a spot of still water, and that'll kill stuff. So something like:
Res 1 -> Pump 1 -> CPU -> MOSFET -> NB -> Rad -> Res 1
Res 2 -> Pump 2 -> GPU1 -> GPU 2 -> Rad -> Res 2

Depending on the type and position of the res, it may also be possible to have them sequentially. If one can gravity-feed to the other, it should work.

 

thanks i going to buy a new setup could you advise me on were to buy what do you think of xspc watercooling

 

out of curriosity, why two reses?

 

because id like the look havin 2 res and gives me option to upgrade to 2 cooling loops in the future

 

u can basicly stick em anywhere as long as your not losing any pump pressure, and if you can fill them extremely full even that can be stopped

 

Putting a radiator between the CPu and GPU's imho is just as effective and cheaper than 2 loops. But then again 2 times the stuff is fun.

 

yes but say i set up the gpu later on, that means iv got to empty the system and rebleed it of air