Got most of the metal work done, just need to fix the fdd/odd mount with popriverts when I get back home. After that I ought to make some power...
Removed the thin piece of original case between motherboard and psu, replaced with 2mm alu plate. Looks lot better than earlier :P [IMG] [IMG]
Day 4 [IMG] [IMG] Like a glove! [IMG]
Day 3: [IMG] PSU backplane standoff threads done, the current standoffs are 2mm too short so they look bit funny in that picture... Holes for...
So when's last time you've seen mod featuring non-*TX hardware? Well here's one: Dell Poweredge C6100 Motherboard and 1.1kW PSU with it's...
The warm air is exhausted through the psu. I use fans that's rpm is over 4k to keep the system cool enough. Not quiet but gets it's job done and...
There we go. [IMG] Had to change 60mm fans and noctua fan to beefier ones due overheating. Now i'm at 72c cpu and 70c gpu maxes with LinX (2h),...
Getting there! [IMG] Faceplate done and painted. This is not the final versio of the insert, was in a hurry when finishing the faceplate and...
Little update for today. Did the gfx mounts, power_on button hole and psu rf/emi shield. [IMG] gfx mounts. [IMG] power button and little...
Little over a month later, after moving out and being employed about 600kms away from every possible tool: [IMG] Re-take on the plate that'll...
AC inlet and exhaust psu fan. [IMG]
Small update: I/O plates hole is done :) [IMG] That is 1.5mm aluminium btw.
Started working on the front panel. [IMG] Fit is perfect but the lid won't close wanna quess why? Shortest distance in the lid is 146mm, so is...
The 30. cal one? I think that's too small for this, it's only 26x16.5x5.8cm LxHxW. E: Did some digging as Varusteleka says the .30cal is...
Separate names with a comma.
