@ph-tvs The source code for my version (works on 2550) is available at http://www.coderforlife.com/projects/lcd/ @sundungas Sorry I never...
First I would like to say that I made some code adjustments that should enable rotary usage. I know it took awhile, but I have been quite busy....
Great! Awesome that things are working quite well and that you like my programs. Hope your future iterations are even better! LCD uses the...
The complete gray should be readable by LCD Smartie if you send the whole thing. Also, using a little extra code in the PIC you could actually...
Great design! A few notes though. I believe you should use the USB ground (not floppy ground) for the fan capacitors. Although, it may not...
To control the outputs, the following commands are available: Output on: 254 87 [1-5] Output off: 254 86 [1-5] Output PWM: 254 102 [1-5]...
Hi sandungas! You have provided extensive feedback on these projects. Thanks! One thing that you bring up time and time again is using...
Awesome! I knew it had to be a wiring or connection issue! But it wasn't one of your connections, which is always difficult. Glad you found it!
The data sheet looks standard. The line offsets are right and it uses the standard HD44780 code / pins. Unless the LCD is bad, there is an issue...
No, his version and mine work on the same exact principles. I used his as a starting point and learned most of everything I know from it. You...
Well, it sounds like there is a problem with the wiring from the chip to the LCD. I would double check everything and make sure all the wires are...
@vali_ave That is a similar problem that was posted recently. The device may not use the standard offsets for the beginning of the lines. There...
That's wrong. The rotatory is not necessary, but the LCD is. The firmware on the chip freezes if it cannot communicate with the LCD. When the...
@zooyork This is typical of a bad wiring... make sure that all of the wires going to the LCD are approximately the same length and not too long....
If it is really being sent by LCD Smartie, then you are probably not processing all the commands it is sending. You should make sure you process...
Separate names with a comma.
