Case Mod - In Progress Chiller's Hybrid Level10

had never problems with that

 

I cracked an acrylic res because I over tightened and put too much teflon on the fitting. Quite a newb mistake.

I'm really liking this mod, you have been doing a great job. Can't wait to see the finished product.

 

Sweet Dominator fins, Man.
-Who knocked your stars down to 3? We 'gotta fix that. Edit: Well, I got you back to 4. That's a start...

 

i know who did that : non-friends .

 

Hm, I've never used teflon tape - just the O-rings. Never had a leak using Bitspower fittings.

 

i'm going to fill up the loop now the 3th pump is installed, own mixture : 25% Ethylene Glycol and 75% PURE water, no demi.

what you see in the measure cup is the Glycol no color pure 100% glycol :



here my koolanc poor in cup on the ZERN res with a snake connector to make it a little bit eassier to fill :



on the drain valve i putted also a tube in a bus filled with my mixture, where the pump can draw it's liquid from when i put the valve open, to make it a little bit eassier to lol :





and here comes the first liquid lol, pumps are now running to get the last micro bubbles out the loop, for now, no leaks found :

 

You're not going to put some dye in the fluid?

 

to color it ?

or you mean against alge ?

Ethylene glycol is from it own against alge.

But first run on this, and then there will come an additive in it, that lowers the temps, also anti-alge, anti-corrosion.
i only have nickel plated in the loop and acryl, so corrosion will not be a problem.

 

Yes, I meant to colour it.

 

nope, no color

because with color pigment in the liquid you can get this :



and without color pigment in the liquid, i will not have that

 

wow very nice looking. may i ask, where did you get those black alan head screws with the red self locking nuts from?

 

model cars and planes.

 

Great video!

Your case cooling are awesome!

Congratulations!

 

It's a miracle !!!!

i get it closed hahahahaha, +200m cable in limited room of 3,5cm lol :



here you see that the plate is a little round, but i put the cable fast fast in to look if i get it closed,
later on the cable will be nice routed and strapped so that the plate doesn't look round :

 

Haha, great video. I love how you roll your tongue on all the "R"s. I presume you're dutch?

Also, good to see that the back panel could be closed - my God, that's a huuuuuge amount of cables. DID you shorten all of them, only using the absolutely minimum lengths needed?

 

OK, I just watched the video. Amazing! I don't even understand half of what you've done there but it's amazing none the less. Well done and +rep.

 

i'm dutch, belgium.

some cables are shorter, but not much lol.

 

last minute adjustment for the vga's :

 

Kinda hard to see what's going on in those 2 pics? You're masking something, but for what? Painting?