Dear PC enthusiasts, today I want to introduce to you my second Thermaltake Core x9 build. This time I want to do something other than last time. I allready made some changes, so you can still see the concept. Basement: Concept: The case will be seperated horizontaly. The lower part of the case will be holding two 480mm/60mm radiators. The new cover on each side of the case will hold one of them. Behind the front I will add an HDD/SSD cage, so you can mount them easily. The PSU will get a new position in the upper of the case. Mounted right behind the front, you got a great view on the PSU and the cables. Next to it I will mount the reservoir and go straight to the midplate into the lower section of the case. To get a good view all over the case I will install acrylic plates in the top and both sides. The sidepanels for the lower part of the case are finished. In fact of missing fans I mounted the radiators without them. The pump is allready mounted at the final position. The HDD cage is integrated in the front of the case. I hope you like it.
It's been some time since the last update on this project. This can be seen in the "Progress Photos" too. Apart from the dust, what happened? - - the radiators (2 x 480 mm / 60 mm) and fans have now found space in the lower chamber. - the wiring was largely completed (io is still missing). - the pass trough by the midplate has been tested; close! - the system has been filled. The final work will be completed in the next few days. Then everything will be removed from the dust again. I hope you like it. Looking forward to finish it.
Looks good! You should have gone dual loops, did it with m X9, worked great, had to change it out though, need a lot of desk for that case!!