ive been working on making a plywood case because the other metal one is chitty.. so i got it all made, everything cut out for floppy and disk drives.. so i plug everything it in fire it up, everything seems to be working fine except that it sends no information to my monitor? also, i try hittin like caps lock on keyboard to see if it lights up but it doesnt, however when i first crank it up, all the lights go on then off as it normally does on startup.. my cathode and fans run and disk drives but alas, no display.. i might have gotten sum saw dust inside but i dun think there wud be enuf and i dont know why it wud cause this so if yall have anythoughts on this.. gimme a few lines..
how can u reset the bios? keep in my mind i dont get any display.. not even like a black screen.. sum reason it just doesnt send a signal ...
tried taking out your vid card + plugging it back in hard? reset your bios using a jumper on the motherboard. It should say in the manual about that
i formatted my cmoputer because i didn't get anything on my screen... turns out the vid card wasn't pushed in far enuff :'(
