nothing.... allright.... let's going on... I build these round discs using 5mm plexy, drawing them first Then I aproximately cut them with the dremel and putting them on it I made then perfectly rounded These discs need a lot of polish... I used a 3mm iron string to make the finger to be flexible With some hit with the hammer the disc won't slide away! Now using one of the bigger discs at the end of the finger and with two of those inside the tube I created a flexible finger. I put inside a colored little tube just for a test . All the colors until now are not definitive. Thanks to the iron string the fingers will be flexible
Just for a test, I cut a plexyglass disc and I made a center hole for put togheter the parts and 3 holes for the fingers Here's what these pieces became
Thanks Then watch this Note that the beer (the can is full!) in not just placed there but the fingers are holding it! Baby's First beer!! I'm so proud of him! He was holding it so hard, I wasn't able to take it easily away from him... Just like the "Real Bender" And also, here it is with a cigar....