Disaster What NOT to do!

yeah notice how is hand in on top of the case, i think he is holding the other side there for the shot. as the pic is so small its hard to see if the pannel is attached or infact just resting over it held up by his hand

 

If you use some GFX editing and use Edge Enhance, you can clearly see his hand is no where near the top of the panel.

 

why not cut the window through the mobo tray? couldn't you see the mobo from behind then? I think it must look very sexy, seeing all those solders

 

Then cut a window in the mobo....Hmmm a new modding idea

 

I think cutting a window in your mobo may have some other effects eg your computer not working at all!!!!

 

actually, thats a interesting story....

once my mate was upgrading his AST computer (err do they even still exist), and he wanted a new case.

The mobo he had was ATX and the case he got was MicroATX, he couldnt be bothered to return the case to get the right one, so he chopped of the bottom corner (in total about 12cm) and it STILL WORKED

 

he does look like hes posing, like they;re just happened to be a camera they (his facial expression), lol :rofl: ROFLMAO if its tru tho, hehe

 

Heh, don't know how Rich managed to get the window on the wrong side

 

I bet he said more then OOOOOPS on that one:rofl:

 

Tee Hee

Must of thought it was one of those "left handed" rigs, gaffaw gaffaw!

 

i woulda never admitted i screwed up, just put the same window on the other side and say thats how its suppoesd to look

-scoob8000

 

Might not be too bad...if he were to add an opague acrylic to the window, say, umm, white or red or something, then add those ultrabright led's behind that in the small gap before the mobo wall...might not look too bad. Hell might look kinda nice.

Assuming the led's dont burn his mobo

 

"Never attribute to malice that which can be adequately explained by stupidity'' -- Hanlon's Razor

 

That would actually look good if you used some of macro's polerising film, like used in project macro black!

It might be faked, though, I dun know.

Signing out...

 

looks like a pretty shoddy cut-out job to begin with, it doesn't look symetrical at all.

 

Well, if he cut in in the wrong panel, you can be asured that he is an amature modder, what's a dremil wouldn't even do him credit!

Signing out...

 

Well actually I have also seen a working mobo with a hole in it. A little while ago back at [H] this guy cut a blowhole in his mobo, just above the southbridge and directly throught e agp slot. It still posted.

 

Yes, but he wasted about 3 PCI slots!

It must have been an AMD...

 

lol that mobo blowhole mod was funny

 

I wonder what he did it with, a hole saw?

I wish I had a board just to aste like that! I'd have about 20 computers floating around my house

Signing out...