Sorry I did miss one it slipped through the net loool number 13 I think the rest are ok aren't they???
Wow mate nice work. I`m really wondering if this would work. You would think you could never get the power 50/50 . But then again it could work just fine. Please test it
Initial no load temps are........wait for it.........-50 per head using a k type contact probe on the GT display -53 in the case COLD
The black is a thinner braid to the blue that is why I used the black, the blue is in limited sizes where I purchase it from so no it will stay black I think
hi fatty , ive se your thread on XS , i have a question , for use dual evap i must divide only the capillar tube and the flex ??? i have a 1/2 compressorand I want to make a simil prommy with 2 evap ....iws possible ??
seb87 I think a 1/2hp would be good the proms is only 1/3hp and yes all I did was split the cap tube and suction line you have to be careful as it is easy to get blockages with twin captubes if one blocks you may not find out about it till its too late, that is why I am going to fit 2 small temp probes near the heads so when the pc switches on I can see straight away if the heads are cooling if they are not off goes the machine so no damage is done
thats cold.. necessary for that temprature though, or overkill for the sake of it ? im off to turn the temprature up
Well this cold will help you squeeze the last few mhz out of your kit my last x800 when I chilled it under a prom would do 610gpu 610mem with no volt mods on air it would do 560/590 my cpu will do 3250 under phase change but on air would probably struggle to hit 3gig
Bad news looks like I killed my gcard yes I didnt insulate it enough and I found small droplets of water where it shouldn't be thats what happens when you rush the insulation process and as I didn't insulate the rear of my pci slot I may have killed that I hope not lool Lesson to be learnt INSULATE EVERYTHING!!!!!
Ouch, that's one expensive paper weight you might have Get it in the airing cupboard for a week or so, it might *just* be ok.
Going to see if it will rma if not then new card so now it looks like I will sell off the duel or mod it back to a single with a chilly1 head and sell it on lol
Its not the under cooling it was the lack of insulation protecting the other components from condensation, also some chips shut down if they get too cold there is a known issue with some of the amd winchester chips and subzero temperatures they will not boot below 0