HUGE job to go sailing in a fan shroud, compared to a yacht :)
I have the pump wired thru a switch to the mains input on the PC PSU (all insulation carefully taken care of) and therefore the pump is on...
I was wondering why it's not important to have the top barb immersed in fluid? I was of the belief that air could get into the fluid stream and...
Of course, a solid state relay should solve all coil breakdown probs as it ain't got no coil :lol: Try something like this:...
Right, i don't want to get bogged down in theory here, mainly because i'm easily bogged :worried: . The rating of the contacts is fine, i would...
Isn't the relay 12 volts dc in this scenario? The contacts are carrying the ac i would have thought, to switch the pump on. The relay coil would...
12 degs above ambient is not excessive but, at 40c in the room......... sod the computer and get some ac in and chill out :lol:
Not had any trouble with an Eheim 1048 wired to the Comp PSU input plug so that as soon as the wall to floor “mains distribution brick” is on...
Do u not rate Silverprop then? Just curious :blah: .
I asked myv65 when the next instalment would be and he said that he had been "out of town" for a while and was just getting round to it.
Ammeter and voltmeter for my dedicated tec psu. :)
As someone who has had a failed double glazing panel for two months where the rain filled up the cavity and then somehow wouldn't disappear until...
www.rswww.com Codes 212-3509 and 212-3688. Shorten the spigot to suit. I have since found better from local plumbers merchant. Just ask for "UPVC...
Tricky question for me. It's a Dubro model fuel tank (24 oz) as used by Joe at Procooling. I think it's a Polythene based plastic. Joe maybe...
With my res in the top i have a built in flow indicator. Very easy to fill and no priming/air trouble. Not pretty for some but neither am I :D...
Very odd this? Just the water wetter (or purple ice) at the correct percentages in distilled water has always been good for me over 12 months use...
Definitely relate to the cuts and scratches that the yeong yang passes on and also the wasted hole saws :grr: :cries: but the end result is...
I went the yy way but would not recommend it. I found that it needed a lot of modding that other cases would not. Also the mild steel case is a...
I tried for some of that but couldn't source it anywhere (in the UK that is). Has anybody in the UK ever got some without hassle or relatives in...
Depends on materials being sealed together. Araldite or Silicone sealant usually sorts most joints out but some polythene (read model fuel tanks)...
Separate names with a comma.