Ok, my 3.3V seems to be A.O.K. Never drops below 3.3 but after unplugging 3 of my case fans I noticed no change in the voltage anywhere...so I...
Lets say I have a PC with a Audigy 2 in it...and the drivers need to be installed.. So I go to the creative website (*******s) and download the...
Separate plugs on separate lines back to the PSU, yes...plugs not used by anythign else no...I don't have enough plugs to do that...
Doubtful...the game (World of Warcraft) is running slower than it was with an older card. And this is a completely fresh OS install too...
hmmm...I was going by what they told me at BFG, they said it had to be consistently above 12V on the +12V rail for the vidcard to operate to...
Hi guys, long time no see...haven't modded much in a long while so haven't posted much in a long while, but I will eventually get back to work on...
Than xman, sent him a message :D
I'm looking to have about 29 holes cut into 1/8" plexi...and since they're so close together I don't wanna do it by hand... its 43 inches by 15...
Anybody here know of or provide reasonably priced CNC service here in the US via mail??? if so I'd be interested...thanx in advance.
Sweet, thanx eddie :D and thanx everyone.
Ok...I'm currently at a semi-standstill because I've bought some plexi for the surface, but I'm not sure if I'll be able to drill all the holes...
So the holesaws are better then? Seems as such considering they have less surface area in contact with the plastic which generates less...
Which is better? Spade bit or hole saw? Cuz I now have access to both for the purposes of drilling the acrylic.
Ok, thanx...now, these holes are going to be pretty close to each other...they are 1 1/8" holes and their center points will be 1 1/2" apart...any...
Hi all...I've got 1 43" x 15" x 3/4" piece of plywood that I'm using for a control panel for my arcade box...I'm plannign on bolting on a 1/8"...
My SNES DVD is one of the bad ones I have to get replaced...I'd recommend checking usenet for the tosec groups...just search your usenet groups...
Dude...arcade boxes emulation consoles are the shizzat! I'm glad you chose to go the way of the two extra buttons, and I see you have some misc...
[img] Got the holes drilled for my new top...since the old one was warped I went today and bought a new piece of wod, marked it up, cut it out...
Yeah, my trackball has a PS/2 converter from Happ...its an older model, but it works and I've tested it...so my trackball will be my primary form...
Well I'm not going for authentic emulator only interfaces or anything like that...I'm probably going to go Win2k with a flash based interface...
Separate names with a comma.