Hey there! I've been around these forums for a while now, not much of a poster but more of an onlooker. I've decided to start a project of my own, its called Kasto. A while ago I bought this case on ebay intending to use it for modding, but I never got to it. As you can see this is a big case, a very big case (picture below). I beleive it's the same case that bard used to put his nice vandal resistance switch on. This case is pretty damn boring, and there's no way around it....well other then modding the hell out of it, which I intend to do, SO LET'S GET STARTED! This is the case, very big, very boring, VERY shallow (only about 1 ft 2 in.) I'll be starting with the front panel. Going to be taking the face plate off the bottom section and place 2 60 MM fans for intake. Needed to cut out some plastic that was in the way, also going to have to do it with the frame of the case. I used some wood for a little bit of a filler and also a place to put the fans, just so I wouldn't waste a bunch of putty, little boo boo on the curve there . This is the first layer of putty that I applied, I also plane on getting rid of the exsisting power and reset switch along with the 2 LED's. That's where I am right now, more updates today though so sit tight!