Discussion in 'Project Logs' started by Y.G Casemod, 8 Mar 2017.
That lighting looks great
In these photos, we will see the 250mm Frozen Q LF Reaction tanks for the aesthetic loops.
The two pans will be placed in the desk legs and the liquid pipes will pass under the desk top.
Remember the two flat pans?
Well, the two systems are separate and will also pass through the flat pans on the front of the desk.
Mounting aesthetic loops in the legs of the desk.
Aerography on the internal SX leg.
In these photos you can also see the effect under UV lights.
Link to the video of the realization.
He begins to take shape.
Internal grid 360 mm DX side and internal grid 480 mm SX side.
Also made biohazard logos.
All in metal, painted and hand aibrushed.
The logos will be applied to the metal meshes mounted on the grid frame.
Other pieces are built .....
In these photos the DX backlit bulkheads (in the first published photos, if you remember you see rough)
In particular, you can see the backlit armor to the motherboard with a complete positioning test on the desk's mb tray.
There is still much to see.
Some saint starts to pull down with the cabling ....
Assembling and wiring of the 6 Poweradjust modules of Aquacomputer.
All mounted on the bay 5.25 (x2) bay.
4 of the 6 modules are used to control the pumps, the remaining two for the rad fans.
Respectively 4 fans on rad from 480 for the cpu loop and 9 fans on the 3 rad 360 loop gpu.
All this requires programming of each PA using Aquasuite software.
It goes on ......
In these photos we will see:
Mounting and connection of the 360mm radiators with tubes and fittings in the DX leg of the desk.
Mounting and testing of the 9 TB Vegas fans of Enermax.
These 3 rad will be for the GPU loop.
Let's get back here.
In these photos we will see the preparation and final assembly of the motherboard with its WB to the processor fittings and everything.
In the details you can see the mounting of a probe on the WB to monitor its specific temperature.
Meanwhile, we manufacture other pieces .......
The installation of the cooling system ......
I shall name you... Sir Bling-A-Lot!
Installation phases of intake fans and internal grille on DX side.
Follows the mounted backlit illuminated panel.
In the photos you see the housing bar for UV lights that will illuminate the grid by highlighting the fluorescent paint of the aerography.
Great work mate
Last part of the worklog before the photos and the final video.
On board in this build there are 2 Titan X.
In the photos we will see the unboxing, the manufacture of backplates customized, airbrushed and backlit, and mounting cards with the WB ready for the liquid on the MB.
Finally, if you like, take a look at this short video intro, which I created to create a story about mod.
Below the link to the intro.
Separate names with a comma.