Scratch Build – In Progress " Dragon Desk" ( build in progress )

Today I fixed discharges of 2 rad, and the plant ...







Qui lo scarico sotto al desk...



....

 

Hello guys, now is the time to build the structure, to the desk, stainless steel 35x35mm.

Here the final rendering.



These are the rods in stainless steel of 2,20Mt

 

Nice Project.

Clean workmanship

But this a planning error for me.






And an error which does not comply with clean workmanship.

 

Why, do you see that you do not like??

 

I ve written 4 sentences.

1- “Nice Project. “

2-“Clean workmanship”

3-“But this a planning error for me.”

4-“And an error which does not comply with clean workmanship.”


I guess you just read the last two only…

It's not important.

Next time . I watch your worklog like this .

 

Hi boys ...
Today realizable shims between the bottom of the desk, and the top plates.
The compartment that is formed ( fairleads ) is of 20mm.











Tomorrow it fixed its plates ....

 

Looking great.

 

Now fixed thicknesses to 3 inner plates.







For the moment I drive with double adhesive.



.............

 

Excellent work, I wish you success!

 

Upgrading works::*

 

Very well executed!

 

Here is a small angular 30mmx20mm, where they will be fixed and the hidden 2 LED strips ...



Seen from below...



Now mark, the other two buttons, which will switch on and off, the individual LED ......

 

It starts to go to settle finally the 4 corners.....



Done.

 

Here we are after a break ....

Today I realized support for HD 4TB



Leaving a space below , for the passage of air::*



Then begin with the drilling on the plate , for the passage of cables :: *





And there it settled :: *



Now is the time to fix and drill support of 2 usb3 , I took on Amazon :: *



And after playing with a small file , here it is how the finished :: *

 

And finally came the stainless steel structure.
Now I just have to make 2 holes to fix the wall, with 2 threading bars from 12mm, which will pass the wall for greater safety.

On the center bar will set you see , at the right height plaque tiltable , rotatable and, where staring at the screen .






....

 

Now once took measures start to make a few holes on the bar will go to support the screen ... to fix his plate :: *





And finally fixed plaque ... you see the various holes are being made, to adjust the height of the screen , in case of replacement, with a larger :: *





Finally here it is set :: *

 

Here we go guys, the final stages ....
I begin to assemble the grids, and the fans on the side::*



Then I do a test with the 2 Lamptron::*



Now I make all electrical connections::*





And now I begin to fill the entire system , with a syringe , filling it up, to bleed the air.

 

Some pictures::*